BD LOOPS Loop Goop 2 - LG2 Two component polyurethane, detector loop, runway light sealant
BD LOOPS Loop Goop 2 - LG2 Two component polyurethane, detector loop, runway light sealant
- Free shipping on most items over $200
- We have 15+ years of industry experience
- GSA, Net 30 and purchase orders available
Description
**Please Note loop sealants can only be shipped UPS ground and only to addresses within the United States**
BDLoops BD LG2 is a two component polyurethane, detector loop sealant. It is designed for use in both asphalt and concrete pavement to provide a weather and chemical resistant waterproof seal. BD-LG2 effectively seals out moisture and provides a tough and durable seal. Permits vehicular traffic immediately after application (see BDLoops.com for installation tips) with no need for lane closure.
BD-LG2 is designed for sealing loops in cold or freezing temperatures. BD-LG2 Detector Loop Sealant exhibits Exceptional chemical resistance to de-icing salts (including 50% by weight potassium acetate), gasoline, hydraulic brake fluid and motor oil. BD-LG2 requires no clean up since the mixing tips are disposable.
To get the most out of your tube of Loop Goop use with a 3/16" wide saw blade, and BD Loops 3/16" Preformed Saw-Cut Loops.
BD-LG2 is primarily used as a fast cure, protective seal for inductance loops. It may be used as a sealant for saw cuts in concrete and asphalt surfaces. BD-LG2 cures in cold and freezing applications. BD-LG2 gels in 2 hours in freezing temperatures. In warmer temperatures it is a quick cure material. See the chart below.
Temperature | Gel Time |
23°F (-5°C) | 120 min |
41°F (5°C) | 45 min |
59°F (15°C) | 15 min |
Greater than 59°F (15°C) | Less than 15 min |
BD-LG2 has no reaction with the asphalt and concrete and therefore will not deteriorate them. It exhibits no "bubbling" or "mushrooming". BD-LG2 will not expand or flow above the joint. BD-LG2 is a 100% solids system, that contains no solvents and is zero V.O.C.
- Self leveling.
- Can cure in freezing temperatures.
- Quick cure when used in warm temperatures.
15 minute gel time in 60° F (16° C) weather.
See “Gel Time” Chart on next page. - 100% Solids, no shrinking occurs when curing.
Contains no solvents. - Zero V.O.C.
- Static mixer included with every cartridge.
- Has no chemical reaction to asphalt or concrete and will not cause deterioration of the surface.
- Exhibits no bubbling or “mushrooming”.
- Low viscosity sealant, flows easily.
- 600ml dual cartridge dispensing gun available. Part # BD-LG2-GUN.
See below for a comprehensive training and educational library from BD Loops
. Debunking Multi-Loop Configurations
. BD Loops Debunks Industry Myth – Loop
Wire Gauge
. BD Loops Debunks Industry Myth – Solid
Vs. Stranded Wire
. BD Loops Debunks Industry Myth – High
Voltage Lines And Loops.
. BD Loops Debunks Industry Myth –
Electrical Lines & Snow Melt Systems Near Loops
. Top 10 Saw-Cut Loop Tips & Tricks
. Replacing Old Loops? Read This!
. An Introduction To Inductance Loops
And Loop Phasing
. Loops And The Effect Of Parallel,
Series, And Phasing
. Loops: How To Insure Proper Placement
And Size
. Myths And Facts About Saw-Cut Loops
. Loops: Understanding And Preventing
Phantom Detections And Air Pockets
. The Importance Of Running The Lead-In
Through Conduit
. Training: Loops, Magnetism, And
Twisted Lead-Ins
. Choosing The Right Size Blade For
Saw-Cut Loops
. Saw-Cut Loop Tips And Tricks
Tests
. Wire Gauge Comparison Test, Small & Large Loops.
. 16AWG Vs. 24AWG Loop Detection
Comparison
. Polyethylene Pipe Insulation Test
. Twisted Wire (In The Loop Itself) Test
. Shovel Test – Running Lead-In Through
Conduit
How To
. Direct Burial Preformed Loop
Installation Instructions
. Saw-Cut Preformed Loop Installation
Instructions
. Installing Loops Under Pavers
. How to Make a Preformed Saw-Cut Loop
Fit Every Time
. Loop Sealant Tips and Tricks
. Fully Seal the Saw-Cut Loop Yoke –
Installation Trick
. Modify a Saw-Cut Loop to a Direct
Burial Loop.
. Automatic Open (Free Exit) Loop
Formula
. Saw-Cut Loop Tips and Tricks
All in stock orders typically ship the same business days or within 1-2 business days. Cut off for same day shipping is 2:30PM Central Time.
LEADTIME
Items with lead times typically ship in 4-7 business days.
FREE SHIPPING POLICY
Orders with free shipping may have longer lead times due to those items being shipped the most economical way. Free shipping on most orders over $195.00 does not include gate operators, loop sealant, and any extreme length or weight items
Our return policy lasts for only 30 days. If 30 days have gone by since your purchase, unfortunately we can’t offer you a refund. Some items such as Gate Operators or custom parts may not be returnable or carry a restocking fee if returned.
Protec Controls accepts purchase orders please contact us.
NET 30
We also support Net 30 terms on our website for easy ordering. Please fill out the form to the right with your company information and we will get your account setup to place Net 30 orders.
GOVERNMENT & GSA
Protec Controls accepts GSA SmartPay cards along with all major credit cards. For government quotes and purchase orders please email govsales@proteccontrols.com